SERVO TYPE
MOUNTING POST
PIN LOCATION
REQUIRED
SERVO ARM
STEERING LINK
LENGTH
AIRTRONICS
All
Futaba
S131, S131SH, S148, S3001, S5101,
S9101,S9201, S9301, S9401, S9403
Futaba
S3401, S9402, S9404, S9450
Futaba
S9303
HiTech
HS-605, HS-615, HS-925, HS-945
HiTech
All other's
JR
NES-507, NES-513, NES-517, NES-901,
NES-4000, NES-4131, NES-4721,
NES-4735, NES-9021,DS-8231
KO
PS-702, PS-703, PS-1001, PS-1003
KO
PS-901BH, PS-902
Multiplex
All
** Use 1 Ball Stud washer on the ball stud when attaching it to the servo arm.
2
25
55B
4**
25
55B
3**
24
55C
4
23
55B
3
25
55B
1
24
55C
1
23
55B
2
23
55B
55B
23
55B
23
1
3
BAG F (Continued)
25
Step F-3
Table 52B
Figure 53
58
Table 52A
Servo Mounting Post Install:
1. Use Tables 52A and 52B to determine how the Servo Mount-
ing Posts (146) should be attached to the Servo
(not included)
.
Trim any flashing from the pins on the Mounting Posts so that
they will seat all the way into the holes in the Chassis and Chassis
Brace.
2. Place a #4 Washer (58) over each of the four 4-40 x 3/8" Cap
Head Screws (17) and attach the Servo Posts to the Servo by thread-
ing a Screw through the upper and lower holes in each Post.
Do not
tighten the Screws yet!
Just snug them up so that the Posts are held
in place, but can still be moved from side to side with a little resis-
tance. The Screws will be tightened at a later step so that the Posts
have the correct spacing.
Figure 52
17
146
58
17
