REAR INNNER
PIVOT SCREWS
53
54
44
49
52
51
19
54
111
48
37
53
51
71
41
66
70
B
B
B
B
BA
A
A
A
AG C (Contin
G C (Contin
G C (Contin
G C (Contin
G C (Continued)
ued)
ued)
ued)
ued)
Step C-3
Rear Arm & Suspension Assembly Install:
1. Place the left rear Hub (66) between the outer rails of the left
rear suspension Arm (51) (Marked "L"). Be sure that the Ball Stud
in the Hub Carrier is pointing towards the front (side with Shock
mount) of the Arm. Position a 0.060" rear Hub Spacer (70) between
the Hub and the Suspension Arm on each side of the Hub.
2. Install a 1/8" E-clip (41) onto one side of the outer rear Hinge
Pin (71). Slide the Hinge Pin into the outside hole on the Suspen-
sion Arm, through each of the two Hub Spacers and the outside hole
in the rear Hub. Secure the Hinge Pin with another 1/8" E-clip.
3. Repeat Steps 1 and 2 for the right rear Hub (65) assembly.
*Note: Read the VLA section in the back of this manual for tips
on when to use the inner holes on the rear Arms and Hubs..
Step C-4
Rear Hub Assembly Install:
Figure 20
Figure 21
1. Attach the plastic rear inner Pivot Block (49) to the rear Pivot
Plate (53) with two 4-40 x 1/2" Flat Head Screws (44) with the Hinge
Pin holes facing rearward. Thread the Flat Head Screws in 3-4 turns
to hold the plastic rear Pivot in place.
2. Locate the small Anti-Squat Shims (48) (read the "Anti-Squat"
section in "Tips" for when to use less of these). Place two Anti-Squat
Shims between the plastic rear Pivot and the rear Pivot Plate , making
sure the flat edge is towards the outside, and tighten the two Screws.
IMPORTANT NOTE:
Ensure that the Anti-Squat Shims are
completely under the plastic rear Pivot to provide a rigid mounting
surface.
3. Attach the rear Pivot Plate to the Chassis (19) using four
4-40 x 3/8" Flat Head Screws (54). Make sure the Pivot Plate is flush
with the Chassis, and the holes in the Pivot Plate and Chassis are
aligned.
4. Slide a rear inner Hinge Pin (52) into the left rear suspension
Arm (51) marked 'L' push the Hinge Pin into the left side of the plastic
rear Pivot Block. Repeat for the right side.
5. Slide the aluminum rear Pivot (37) over the rear inner Hinge
Pins with the flat side facing towards the rear of the car.
6. Slide the Motor Guard (111) under the aluminum rear Pivot
and align the holes in the Motor Guard, rear Pivot, and rear Pivot
Plate.
7. Apply a drop of Thread Lock (21) to two 4-40 x 3/8" Flat
Head Screws and thread them through the Pivot Plate and Motor Guard,
into the aluminum rear Pivot and tighten
If you notice some "slop" between the rear Arms and the Pivots,
you may need to losen the Screws securing the aluminum rear Pivot
and push forward on the Pivot while re-tightening the Screws.
54
9
44
52
71
41
70
48
