B
B
B
B
BA
A
A
A
AG D (Contin
G D (Contin
G D (Contin
G D (Contin
G D (Continued)
ued)
ued)
ued)
ued)
13
Step D-4
Step D-5
1. Insert a 5mm x 8mm Ball Bearing (80) into the center of the
Diff Gear (81).
2. Press a 3/32" carbide Diff Ball (82) into each of the 12 small
holes in the Diff Gear. There should be a total of twelve Balls in-
stalled.
A
clean, dry
finger can be used to smooth out and spread the
Diff Grease.
3. Apply a small amount of Clear Diff Grease (78) to cover the
Diff Balls on both sides of the Gear.
IMPORTANT NOTE:
There are two sets of Balls in Bag D.
Be certain to use the Balls that are packaged separatly (12 total) in
Step D-4. There is a second set of eight 5/64" Balls packaged with
Thrust Washers in the bag. These Balls will be used in Step D-6.
Figure 30
Diff Gear:
Diff Gear to Male Outdrive:
Figure 29
1. Apply a small bead of clear Diff Grease (78) to the exposed
side of the Diff Ring (79). Carefully place the Diff Gear(81) over the
bearing boss, so the Diff Balls (82) and Diff Gear rest flat against the
Diff Ring.
IMPORTANT NOTE:
It is a good idea to hold the Diff Nut in
place, with the Allen Wrench, so the Diff Nut is not pushed out of
the Outdrive/Diff Half.
80
82
80
82
81
GREASE BOTH
SIDES
79
81
82
GREASE