B
B
B
B
BA
A
A
A
AG D (Contin
G D (Contin
G D (Contin
G D (Contin
G D (Continued)
ued)
ued)
ued)
ued)
18
Step D-14
Slipper Clutch Assembly:
1. Slide the Slipper Backing Plate (104) over the Top Shaft (90), aligning the flat sections on the Top Shaft (90) with the flat sections of
the Slipper Backing Plate.
2. Place the Slipper Pad (105) on one side of the 86 tooth Spur Gear (106) and align the notches on the Spur Gear with the notches on the
Slipper Pad.
3. Place the Spur Gear, Pad side first, over the Top Shaft. The Slipper Pad should rest against the Slipper Backing Plate.
*NOTE: Ensure that the Slipper Pad remains indexed in the Spur Gear.
4. Install the second Slipper Pad to the exposed side of the Spur Gear. Again, align the notches on the Spur Gear with the notches on the
Slipper Pad.
5. Place the second Slipper Backing Plate over the Top Shaft so that the large, flat surface of the Backing Plate rests against the Slipper
Pad.
6. Place the Slipper Spacer (107), long side first, onto the Slipper Shaft and against the outer Slipper Backing Plate.
7. Place the silver Slipper Spring (108) over the Slipper Shaft, followed by the Slipper Spring Retaining Washer (109) and secure with the
4-40 Locknut (110).
IMPORTANT NOTE:
Before tightening the Locknut, check to see that the Slipper Pads are properly aligned with the notches on both
sides of the Spur Gear. If not, align them before proceeding.
8. Tighten the 4-40 Locknut all the way down, and then back it off four complete turns (360
o
x 4). This is a good starting point for
adjustment. Final adjustment can be made later.
110
109
108
107
104
105
106
105
104
90
Figure 39
107
109
110
108
