B
B
B
B
BA
A
A
A
AG B (Contin
G B (Contin
G B (Contin
G B (Contin
G B (Continued)
ued)
ued)
ued)
ued)
7
Step B-11
*NOTE:
Assure that the grooves on all of the
front
Turnbuckles are located on the drivers
right
-hand side for easier adjustment later.
1. Snap one end of a steering Tierod assembly (Figure 16B) to the Ball Stud (11) in the steering Servo Saver Bottom (1). Snap the other
end to the Ball Stud (26) in the left Spindle (28).
2. Attach the second steering Tierod to the right side of the car.
Steering Tierod Install:
Step B-10
There is a small container/package of White Grease (87) in this
bag. It is recommened that a small amount of this be applied to the
threads of the Turnbuckles before trying to thread on thte plastic Rod
Ends. Please use this lube sparingly as it will be used during the as-
sembly of the Differential as well.
*NOTE: The two ends of the Turnbuckle are threaded opposite.
The end closest to the groove, next to the square, has standard right-
hand threads, the other end has left-hand threads. This allows the
length of the Tierods, once installed, to be adjusted without remov-
ing them.
1.Thread a Plastic Rod End (45) onto each End of a
2-3/8" Turnbuckle (46). Tighten both Rod Ends equally until the Rod
is the same length and the Rod Ends are in the same orientation as the
assembled Tierod in Figure 16B. Make two of these Tierod assem-
blies.
Figure 16A
Figure 16B
Steering Tierod:
28
1
26
11
45
Figure 17
45
46
72
45
87