POCKET ROCKET™
BATTERY INSTALLATION INSTRUCTIONS
Need Help?
Visit our website at
www.razor.com
or call toll-free at
866-467-2967
Monday - Friday 8:00am - 5:00pm Pacific Time.
1
CAUTION:
To avoid potential shock or other injury, turn power switch OFF and discon-
nect charger before removing or installing the batteries. Failure to follow these steps in the
correct order may cause irreparable damage.
Figure 1
Figure 2
Step 1
Using a 5mm Allen wrench, remove the three
hex bolts: one located on the bottom and one
on each side of the body fairing. Remove fairing
from the unit.
Using a 5mm Allen wrench, remove the two
hex bolts that hold the seat fairing to the frame
and remove the fairing by sliding it to the rear of
the bike.
Step 2
Tools Required:
(
Not included
)
A. 4mm Allen wrench
B. 5mm Allen wrench
WARNING
Do not use non-Razor products with your Razor electric
scooter. The scooter has been built to certain Razor
design specifications.Certain aftermarket parts may or
may not be compatible.
As with all consumer electronics, use of compatible
batteries and chargers is strongly recommended. Failure
to do so may pose a fire hazard.
Examine the battery, charger and their connectors for
excessive wear or damage each time you charge the
battery. If damage or excessive wear is detected, do not
use the charger or the vehicle until you have replaced the
worn or damaged part.
Battery connectors may contain lead and lead
compounds.
Wash your hands after handling.