FLANGING MACHINE
87
F-200
13.3 REPLACEMENT OF DIGITAL DISPLAY UNIT’S BATTERY
Forming head: 1. Digital display
F-200 flanging machine is equipped with digital display unit (pictured above).
Digital measuring unit is located to the forming device. It displays the pipes inside radius.
Digital measuring unit is battery operated (silver oxide cell SR44). When battery power is
low “B” appears in the upper left corner of the LCD .
See separate Digimatic Scale Unit 572 manual for changing battery. (Chapter 10.)
After the battery changing the digital measuring unit have to calibrate.
Move the forming head to the upmost position against the stopper and fasten screws.
Preset the display according the Digimatic Scale Unit 572 manual (Chapter 10.) Preset
value is the same as minimum radius of machine.
Presetting value is 6.5mm. at 2.5mm of forming pin housing position.
Mount the smallest tube clamps into the machine. Turn the forming pin into horizontal
position. Adjust the height of the forming pin so that it cannot collide with the clamps.
Drive the slide to front position (air buffers). Set the forming pin against the jaw. Set the
reading of the digital measuring unit. Clamp diameter /2. For example: tube clamp =25.
Preset value is 12.5.
NOTE!
¨
Notice the position of forming pin housing.
Position of forming pin housing effects to the level of forming tool.
If the forming pin housing position is not 2.5mm the reading of digital measuring
units and pipe inside radius are not equal. (See chapter 6.2.6)
Summary of Contents for F-200
Page 1: ...F 200 FLANGING MACHINE INSTRUCTION MANUAL...
Page 97: ......
