T-Drill F-200, Instruction Manual

Page: 63 / 98

FLANGING MACHINE
63
F-200
8.4 THE ADJUSTMENT OF THE BURNER FLAME AND HEATING
TIME
L
DANGER! When using the heating device, always keep the space in front of
the pipe end completely free from obstacles.
NOTE!
¨
Always observe the necessary caution when carrying out the
adjustment of the burner flame and keep proper fire extinguishing equipment at
hand.
1. Install the correct burner nozzle.
2. Install the pipe clamp
3. Drive the frame forward, until it stops.
4. Turn the forming pin into flanging position.
5. Open the clamping jaws and insert the pipe into the clamp so, that the end of the pipe
is against the forming pin. Close the clamping jaws.
6. Open the valve of the gas supplies and adjust the gas pressures.
The oxygen pressure should be 0,2-0,5 MPa and the corresponding propane pressure
about half of it. The maximum air pressure of the pilot burner is 0,2 MPa.
7. Make sure the way of flanging selector switch is in the flame adjustment position .
8. Press the work cycle start push-button , the burner arm will then move upwards
and move towards the pipe. The burner enters into the pipe.
NOTE!
¨
Should there be any obstacle on the way of the burner, press
immediately the EMERGENCY STOP push-button completely down.
9. Stop the machine.