FLANGING MACHINE
55
F-200
Recommendation! Make a setting value table for your own range of pipes, or use
the program library to store settings.
Library-screen (without pyrometer)
7.1.1 SETTING OF THE PIPE END FORMING DEVICE
L
DANGER! Before closing the clamping jaws, make sure they can move freely -
the jaws may crush your hands!
Pipe size setting
1. Fasten the pipe
2. Turn the forming pin into its starting position by turning the clamp control switch,
at the same time turning the control switch of the tool into
- position.
3. The pipe forming device must be in such position, where the top of the unit is up.
If this is not the case, turn the spindle in the correct position by pressing shortly the
push-button, until, the pilot lamp lights.
4. Set the “Start Pos.” to zero (0.0mm) on the display (See previous chapter).
5. Drive the frame forward towards the pipe, by turning the clamp control switch, at
the same time turning the control switch of the frame into the
- position, until the
forming pin almost reaches the pipe.
6. Stop the machine and push the protective hood backward. Check that the forming pin
can freely enter into the pipe. Should this not be the case, then adjust the position of the
pin.
L
DANGER! If the tube is inserted too deep, the machine can be damaged!
Do not attempt to make an oversized flange.
Summary of Contents for F-200
Page 1: ...F 200 FLANGING MACHINE INSTRUCTION MANUAL...
Page 97: ......
