T-Drill F-200, Instruction Manual

Page: 72 / 98

INSTRUCTION MANUAL
72
10. THE BEVELING OF THE PIPE END (OPTIONAL)
Beveling of the pipe
• The beveling can be executed on carbon steel and copper pipes.
• The outer diameter of the pipe to be beveled can be between Ø 42,4 and 219,1mm.
• The wall thickness of the pipe to be beveled must be more than 3mm.
10.1 WORKING INSTRUCTIONS FOR BEVELING
The outer diameter of the pipe to be beveled can be between �42,4 and �219.1 mm.
NOTE!
¨
The bevel can be produced only, if the F-200 machine has been ordered
with this optional accessory.
10.1.1 THE INSTALLATION OF THE BEVELING TOOL
1. Remove the forming pin (see chapter “6.3.1 Changing of the forming pin
”, points 1-12)
2. Install the beveling tool into the chuck of the pin and tighten it carefully.
3. Change the fixing screw at the left side of the arch for a M8x25 fixing screw and tighten
it properly.
4. Tighten the locking pin on the fixing screw by means of a 17 mm wrench (2, 4, 5).
5. Tighten the beveling tool in the locking nut by means of a M8x16 hexagon socket
screw, so as to prevent the tool from turning. Use a washer.
1
2
3 4 5
Beveling tool: 1. Arch, 2. Beveling tool, 3. Fixing screw, 4. Locking pin, 5. Hexagon socket
screw