T-Drill F-200, Instruction Manual

Page: 69 / 98

FLANGING MACHINE
69
F-200
6. Stop the machine and push the protective hood backward. Check that the expansion
pin can freely enter into the pipe. Should this not be the case, then adjust the position
of the pin: loosen the locking screws of the slide and adjust the position of the slide by
turning the adjusting bolt, that a distance of about 5 mm remains between the pipe and
the expansion pin.
7. Tighten one screw for arrestment of the movement.
8. Pull the protective hood on its place and start the machine.
9. Drive the frame forward until the expansion pin is completely inside the pipe.
10. Stop the machine and push the protective hood backwards.
11. Adjust the slide in such way, that the expansion pin just touches the inner surface of
the pipe. Tighten the locking screws (4 pcs).
12. Start the machine.
13. Drive the frame to its rear position by turning the switch at the same time turning
the control switch of the frame into the position
.
14. Set the value (Start pos.) of the program to 40mm. (See chapter 6.2.6)
15. Adjust the turning angle of the expansion pin by turning the clamp control switch
and turning at the same time the control switch of the tool into the position . Drive
the cylinders out fully. Turn the adjusting bar so that cylinders are in upmost position and
tighten the locking bushing to the 24 Nm.
16. Drive the frame forward until it stops.
1
2
3
The adjustment of turning angle of expansion pin: 1. Locking bushing, 2. Adjustment lever
3. Digital display unit for leveling of forming tool