FLANGING MACHINE
33
F-200
6.3 THE MACHINE MECHANICAL SETTINGS
6.3.1 CHANGING OF THE FORMING PIN
The identification of the forming pin
The forming pin which is part of the standard delivery has no particular markings. The
forming pin intended for forming stainless steel bears however the stamped mark “SC”
near the width across flats.
SC
SC
1
2
3
4
1
2
3
4
Forming pins: 1. Standard mild steel pin, 2. ”SC” marked for stainless steel, 3. Expansion
pin, 4. Grooved pin, can be used for hot forming of mild steel pipes
The changing of the forming pin
L
DANGER! Before closing the clamping jaws make sure they can move freely -
the jaws may crush your hands!
1. Start the machine by pushing the power on push-button
.
2. Close the clamping jaws by turning the clamp control switch to
, in order to
pressurize the hydraulics. Keep the switch in this position until the jaws are closed.
3. Drive the carriage in the rear position by turning the control switch of clamps in
position
and turn at the same time the control switch of the carriage to the position
(reverse carriage).
4. Turn the forming pin in flanging position by means of the switch
and at the same
time turn the control switch of the tool to the position
.
5. Press the EMERGENCY STOP button completely down.
1. Key-switch (1=auto, 2=manual), 2. Brake release- push button,
Summary of Contents for F-200
Page 1: ...F 200 FLANGING MACHINE INSTRUCTION MANUAL...
Page 97: ......
