INSTRUCTION MANUAL
42
6.3.5 THE PRESSURE REGULATION OF THE CLAMPING JAWS
NOTE!
¨
Only a person authorized by the employer is allowed to carry out the
pressure regulation of the clamping jaws
1. Set the machine so, that the work cycle can be started - drive the frame to the start
position and the spindle into the correct position.
2. Fasten the mobile manometer of the hydraulics, included in the machine delivery, to
the pressure measuring point of the pipe fastening clamp.
3. Start the hydraulics by pressing the power on
push-button.
4. Open the clamping jaws by turning the clamp control switch and close them by
turning the clamp control switch.
5. Adjust the pressure of the jaws to the desired value (look at the manometer) by
operating the pressure regulator of the jaws.
6. Open the pressure switch SP1 4-5 turns (counterclockwise). Make sure there is
sufficient screw thread.
7. Press the cycle start
press-button and keep it pressed down. At the same time
another person is to adjust the pressure switch SP1 screwing it down until the work cycle
starts.
8. Stop the work cycle by pressing the cycle stop
push-button and adjust the pressure
switch SP1 by opening it another 1/4 of a turn.
9. Try if the pipe remains in its place without any damages during the entire work cycle
and if there is any trouble, carry out the adjustment once again.
Summary of Contents for F-200
Page 1: ...F 200 FLANGING MACHINE INSTRUCTION MANUAL...
Page 97: ......
