T-Drill F-200, Instruction Manual

Page: 22 / 98

INSTRUCTION MANUAL
22
No. Denomination Description of the function
1 Selector of the forming Selects the forming of the pipe end (see separate table
on next page)
2 Selector of the way of forming Selects either cold or hot forming (see separate table
on next page)
3 Selector of the flanging mode Selects the way of flanging the pipe (see separate table
on next page)
4 Heating time regulator Sets the heating time, i.e. the time during which the
heating gas valves are open. One number on the scale
represents 20 seconds.
5 Regulator of the time of the
first return movement in multi-
stage flanging
Sets the time during which the flange is being spinned
before the first return movement. One number on the
scale represents 1 second
6 Regulator of the time of the
second return movement in
multi-stage flanging
Sets the time during which the flange is being spinned
before the second return movement. One number on
the scale represents 2 seconds.
7 Power on push-button Puts the machine on standby, starts the hydraulic
pump and connects the power to the control logic.
8 Stop button Stops the hydraulic pump motor and interrupts the
power to the control logic
9 Heating stop push-button Stops the heating during the automatic work cycle,
but the operations of the work cycle will continue
until finished. Drives the heating burner arm to lower
position, whereupon the main air valve opens.
10 Heating pilot lamp Indicates that heating cycle is on.
11 Cycle start push-button Starts the automatic work cycle when the frame is at
starting point. Starts the gas flow of the main burner
during the heating cycle.
12 Cycle interrupt push button Interrupts the automatic work cycle, the slide of the
burner is retracted to the rear and the arm of the
heating burner is lowered.
No. Denomination Description of the function
13 Control switch of pipe clamp Closes or opens the pipe clamp
14 Control switch of frame Moves the frame forward or back
15 Control switch of the tool Moves the tool into horizontal position (return
movement) or into vertical position (flanging position)
16 Push-button for rotary
movement of the forming tool
Makes the forming tool rotate
17 Emergency switch (red STOP
button)
Stops the machine in case of danger (see: emergency
stopping of machine)
18 Key-switch To connect control of spindle motor brake
19 Brake release push button When pressing this push-button, the spindle motor
brake is released and the slide can be turned manually