FLANGING MACHINE
27
F-200
No.
Name
Function
13
Pressure switches
(Behind service cover)
Pressure switches control automatic operation and in some cases
limit the effect of the hydraulic cylinders.
Pressure switches control automatic operation and in some cases
limit the effect of the hydraulic cylinders.
SP1 indicates that the clamp is closed. Set pressure switch so that
pressure is just below the clamp working pressure (Preadjusted
to 120 bar, if pipe tends to deform because of the clamping force,
decrease the clamping pressure, see picture on next page). If
pressure deforms the pipe, the forming pin slide and forming pin
may be defected.
SP2 indicates that forming pin is in start position. Pressure switch is
set just below the main pressure (155 bar).
SP3 regulates the working pressure of the forming pin. Pressure
switch is set just below the main pressure (155 bar).
Clamp pressure regulator Clamp closed pressure switch (SP1)
If you change the clamp pressure set the pressure switch SP1 about 10 bars below the clamp pressure.
See attached hydraulic documents and pressure sensor operating instructions for further instructions.
14
Throttle valves of hydraulic
cylinders (marked according
to hydraulic diagram).
(Behind service cover)
Flow restrictor valve (tool to ready position) for forming pin flanging
movement speed. Set as required (recommended setting - 17 sec
from starting position to final position).
Flow restrictor valve (tool to start position) for forming pin return
movement speed. 4 sec.
Flow restrictor valve (Chamfering speed adjustment, (optional)) for
creeping speed of moving frame forward movement.
Frame moving speeds are preset at following: backwards 27
mm/s and forwards 19 mm/s. Clamp moving speeds are preset at
following: closing 9-10 mm/s and opening 28 mm/s.
15
Main pressure regulator
(Behind service cover)
Setting pressure 120 bar
Auxiliary pressure- setting pressure 80 bars.
Summary of Contents for F-200
Page 1: ...F 200 FLANGING MACHINE INSTRUCTION MANUAL...
Page 97: ......