FLANGING MACHINE
37
F-200
6.3.3 ADJUSTING OF FLANGING RADIUS
See chapter 6.3.4 Fastening of the pipe and clamp changing, item 8: Buffer plates.
NOTE!
¨
Before adjusting cut the power.
1. Push emergency button down and turn the key to position 2 “brake open”.
2. Push the release brake
push-button (on the side of control panel) down and turn
the forming head until the tool is upside down.
3. Open the locking screw and adjust the tool housing.
4. Adjust the turning radius wanted of the forming pin by turning the eccentric sleeve. As
turning radius you can select a value between 2,5…7,5mm.
5. Tighten the locking screw.
6. After the forming tool adjusting adjust the front stop position with buffer plates.
7. Check the level of the forming head and adjust it as instructed on chapter 7.1.1 Setting
of the pipe end forming device.
Summary of Contents for F-200
Page 1: ...F 200 FLANGING MACHINE INSTRUCTION MANUAL...
Page 97: ......
