Sun Microsystems Netra 210, Service Manual

Page: 45 / 122

Chapter 3 System Board Components 3-5
5. Press the memory down into the slot firmly until it clicks into place.
See
FIGURE 3-5
.
FIGURE 3-5
Pressing Memory Into the Slot
6. Repeat Step 3 to Step 5 for each memory module to be installed.
7. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.
■
Otherwise, install the air duct and top cover, install the server into the rack,
power on the server, and verify the installation.
■
See Section 5.1, “Installing the Top Cover” on page 5-1 .
■
See Section 5.3, “Installing the Server Into the Rack” on page 5-4 .
■
See Section 5.4, “Powering On the Server” on page 5-6 .
■
See Section 5.5, “Verifying the Installation” on page 5-7 .
3.3 Replacing the PCI Card
3.3.1 Removing the PCI Card
1. Power off the server, remove the server from the rack, and remove the top cover
and airduct.
■
See Section 1.3, “Powering Off the Server” on page 1-3 .
■
See Section 1.4, “Removing the Server From the Rack” on page 1-4 .
■
See Section 1.6, “Removing the Top Cover” on page 1-7 .