Sun Microsystems Netra 210, Service Manual

Page: 38 / 122

2-10 Netra 210 Server Service Manual • March 2006
8. If you are replacing a defective DVD module, follow these steps. Otherwise, go to
Step 9 .
a. Install the air duct and top cover.
See Section 5.1, “Installing the Top Cover” on page 5-1 .
b. Install the server into the rack.
See Section 5.3, “Installing the Server Into the Rack” on page 5-4 .
9. Power on the server.
See Section 5.4, “Powering On the Server” on page 5-6 .
2.4 Replacing the System Configuration
Card
The system configuration card (SCC) is an identification card that uses smart card
technology.
2.4.1 Removing the SCC
1. Power off the server and open the bezel.
■
See Section 1.3, “Powering Off the Server” on page 1-3 .
■
See Section 1.5, “Opening the Bezel” on page 1-5 .
2. Locate the SCC.
The SCC is located at the left side of the front panel.
3. If present, remove the tie wrap securing the SCC in the slot.
4. Grasp the SCC and pull it from the slot.
See
FIGURE 2-9
.