Sun Microsystems Netra 210, Service Manual

Page: 101 / 122

Chapter 5 Finishing Up 5-5
2. Ensure that the bezel is properly closed.
See Section 5.2, “Closing the Bezel” on page 5-3 .
3. Lift the server to its position on the rack and begin to slide it in.
See
FIGURE 5-6
.
FIGURE 5-6
Beginning to Slide the Server In
4. Continue to slide the server back into the rack.
5. When fully seated, secure the server in place by tightening the screws at both
sides of the bezel.
See
FIGURE 5-7
.
FIGURE 5-7
Securing the Server
6. Reconnect the following cables to the rear panel of the server:
■
Network cables
■
ALOM cables
■
Serial cables
■
USB cables
■
PCI connector cables
■
SCSI cables