Sun Microsystems Netra 210, Service Manual

Page: 50 / 122

3-10 Netra 210 Server Service Manual • March 2006
FIGURE 3-13
Sliding the PCI Card Retainer Back
12. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.
■
Otherwise, install the air duct and top cover, install the server into the rack,
power on the server, and verify the installation.
■
See Section 5.1, “Installing the Top Cover” on page 5-1 .
■
See Section 5.3, “Installing the Server Into the Rack” on page 5-4 .
■
See Section 5.4, “Powering On the Server” on page 5-6 .
■
See Section 5.5, “Verifying the Installation” on page 5-7 .
3.4 Replacing the SAS Board
3.4.1 Removing the SAS Board
1. Power off the server, remove the server from the rack, and remove the top cover
and airduct.
■
See Section 1.3, “Powering Off the Server” on page 1-3 .
■
See Section 1.4, “Removing the Server From the Rack” on page 1-4 .
■
See Section 1.6, “Removing the Top Cover” on page 1-7 .
2. Locate the SAS board.
The SAS board is located under the PCI card at the left rear of the system board.
3. Remove the PCI card.
See Section 3.3.1, “Removing the PCI Card” on page 3-5 .
4. Disconnect the two SAS cables from the SAS board.
See
FIGURE 3-14
.