Sun Microsystems Netra 210, Service Manual

Page: 93 / 122

Chapter 4 Chassis Components 4-21
FIGURE 4-27
Tightening the SAS IF Assembly Screws
6. Connect the cables to the SAS IF assembly in this order:
■
The two SAS cables at
J7
■
The cable from the power supply at
J501
■
The cable from the DVD assembly at
J5
See
FIGURE 4-28
.
FIGURE 4-28
Connecting Cables to the SAS IF Assembly
7. Install the hard drives.
See Section 2.2.2, “Installing the Hard Drive” on page 2-4 .
8. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.
■
Otherwise, install the air duct and top cover, close the bezel, install the server into
the rack, power on the server, and verify the installation.
■
See Section 5.1, “Installing the Top Cover” on page 5-1 .