Sun Microsystems Netra 210, Service Manual

Page: 83 / 122

Chapter 4 Chassis Components 4-11
■
Fan 5 -
J5
See
FIGURE 4-12
.
FIGURE 4-12
Disconnecting the Fan Cable
5. Remove the fan and set it aside on an antistatic mat.
6. Repeat Step 4 and Step 5 for each fan to be removed.
Caution – Do not power on the server without the fans installed.
7. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.
■
Otherwise, replace the fans.
Go to Step 4 of Section 4.4.2, “Installing Fans 4 and 5” on page 4-11 .
4.4.2 Installing Fans 4 and 5
1. Remove the server from the rack and remove the top cover.
■
See Section 1.4, “Removing the Server From the Rack” on page 1-4 .
■
See Section 1.6, “Removing the Top Cover” on page 1-7 .
2. Locate where the fans install.
Fans 4 and 5 install between the SAS IF assembly and the power supply at the right
front of the chassis.
3. If either Fan 4 or Fan 5 is installed, lift it from the bracket.
4. Remove the replacement fan from its shipping container and antistatic packaging.