Sun Microsystems Netra 210, Service Manual

Page: 43 / 122

Chapter 3 System Board Components 3-3
FIGURE 3-2
Lifting the Memory Out of the Socket
5. Set the memory aside on an antistatic mat.
6. Repeat
Step 3
to
Step 5
for each memory module to be removed.
7. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.
■
If you are replacing memory, go to Step 3 of Section 3.2.2, “Installing Memory” on
page 3-3
■
Otherwise, install the air duct and top cover, install the server into the rack, and
power on the server.
■
See Section 5.1, “Installing the Top Cover” on page 5-1 .
■
See Section 5.3, “Installing the Server Into the Rack” on page 5-4 .
■
See Section 5.4, “Powering On the Server” on page 5-6 .
3.2.2 Installing Memory
1. Power off the server, remove the server from the rack, and remove the top cover
and airduct.
■
See Section 1.3, “Powering Off the Server” on page 1-3 .
■
See Section 1.4, “Removing the Server From the Rack” on page 1-4 .
■
See Section 1.6, “Removing the Top Cover” on page 1-7 .