Sun Microsystems Netra 210, Service Manual

Page: 35 / 122

Chapter 2 Storage Components 2-7
2.3 Replacing the DVD Module
2.3.1 Removirng the DVD Module
1. Power off the server, remove the server from the rack, open the bezel, and remove
the top cover and airduct.
■
See Section 1.3, “Powering Off the Server” on page 1-3 .
■
See Section 1.4, “Removing the Server From the Rack” on page 1-4 .
■
See Section 1.5, “Opening the Bezel” on page 1-5 .
■
See Section 1.6, “Removing the Top Cover” on page 1-7 .
Note – It is not necessary to remove the air duct.
2. Locate the DVD module.
The DVD module is located at the left of the front panel.
3. Pull and hold the release tab at the right rear of the DVD module.
See
FIGURE 2-5
.
FIGURE 2-5
Removing the DVD Module
4. While holding the release tab, pull the DVD module out through the chassis front
panel.
See
FIGURE 2-5
.
5. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.