Sun Microsystems Netra 210, Service Manual

Page: 87 / 122

Chapter 4 Chassis Components 4-15
FIGURE 4-18
Removing the DVD Assembly From the Chassis
Caution – Do not power on the server without the DVD assembly installed.
9. Determine your next steps:
■
If you were directed here by another procedure, return to that procedure.
■
Otherwise, replace the DVD assembly.
Go to Step 3 of Section 4.5.2, “Installing the DVD Assembly” on page 4-15 .
4.5.2 Installing the DVD Assembly
1. Remove the server from the rack, open the bezel, and remove the top cover and
airduct.
■
See Section 1.4, “Removing the Server From the Rack” on page 1-4 .
■
See Section 1.5, “Opening the Bezel” on page 1-5 .
■
See Section 1.6, “Removing the Top Cover” on page 1-7 .
2. Locate where the DVD assembly installs.
The DVD assembly installs at the left front of the chassis.
3. Remove the replacement DVD assembly from its shipping container and antistatic
packaging.
4. Position the DVD assembly over the chassis, and lower the front end down into
the chassis front panel.
See
FIGURE 4-19
.