SF-8200 Operation Manual
6
/
76
PRECAUTIONS
1 GENERAL PRECAUTIONS
Before installing and using the instrument for the first time, please read the instructions in the
manual carefully and strictly observe the operating procedures and precautions. The instrument must be
operated in accordance with the methods specified in this manual. Failure to use the device in accord-
ance with the methods specified in this manual may damage the protection provided by the device.
Before reading the manual, make sure you understand the following logo. Please refer to "Chapter 1 3.1
Instrument Composition."
Attention
Be careful of burns
Laser radiation
Biohazard
Protect the ground
Any failure to observe the above marks and operate the instrument incorrectly may result in injury to
the operator, adverse effects on output, and potential hazards of property damage.
This product is a clinical testing instrument, Based on the analysis results, the doctor is required to
consider the clinical test results and other test results at the same time.
2 NOTES ON THE USE OF BIOLOGICAL PRODUCTS
For all biological products (reagents, calibrators, quality control plasma and patient plasma, etc.),
please read the precautions regarding potential contamination carefully.
1) Do not eat or smoke in areas where biological products are used;
2) Do not use expired reagents;
3) Reagents are chemicals used for in vitro diagnosis and can not be used as medicines.
4) When using biological products, please wear disposable rubber gloves, if the biological products come
into contact with your skin wounds or mucous membranes, rinse immediately with water and see a doc-
tor;
5) Dispose of all used biological waste products according to local laws or regulations (eg. heat steriliza-
tion, discard, waste water treatment with sodium hypochlorite, etc.).
3 NOTES ON THE USE OF THE INSTRUMENT
1) The instrument has protective measures in the transport package. It must be installed by a profes-
sional engineer trained by our company or authorized engineer of our company.
2) All the warning signs, the operator must check the instructions in the relevant content, identifying po-
tential hazards;