Stryker Flyte 0408-600-000, Instructions For Use Manual

Page: 7 / 120

0408-600-705 Rev-AB EN
www.stryker.com 7
Cleaning
WARNINGS:
• ALWAYS remove the power pack, any type power cord, earphone, and comfort
pads from the helmet before cleaning.
• DO NOT sterilize any component.
CAUTIONS:
• DO NOT use solvents, lubricants, or other chemicals, unless otherwise
specified.
• DO NOT allow liquids or moisture into the fan or electrical connections of the
helmet.
• DO NOT allow debris to enter the helmet fan.
NOTES:
• The cord may be the power cord or the dictation power cord.
• To clean the power pack, see the instructions for use supplied with the Flyte
charger.
To Clean the Surgical Helmet and Cord
1. Remove all the accessories from the helmet. Discard the comfort pads.
2. Wipe the helmet, cord, and power pack holster with a soft cloth dampened
with a nonabrasive, hospital disinfectant.
3. Dry the equipment with a lint-free towel or medical-grade compressed air.
4. Clean the headlight lens with lens tissue. See the instructions for use supplied
with the lens tissue.
5. See the Storage and Handling section.
Storage and Handling
CAUTION: ALWAYS store the equipment within the specified environmental
condition values throughout its useful life. See the Specifications section.
To ensure the longevity, performance and safety of this equipment, use of the
original packaging material is recommended when storing or transporting this
equipment.
Disposal/Recycle
WARNING: ALWAYS follow the current local recommendations and/or
regulations governing environmental protection and risks associated
with recycling or disposing of the equipment at the end of its useful
life.
To comply with European Community Waste Electrical and
Electronic Equipment (WEEE) Directive 2012/19/EU, this
device should be collected separately for recycling. Do
not dispose of as unsorted municipal waste. Contact local
distributor for disposal information. Ensure infected equipment
is decontaminated prior to recycling.
Troubleshooting
WARNING: DO NOT service this equipment, unless otherwise
specified. If you require service, contact your Stryker sales
representative or call Stryker customer service. Outside the US,
contact your nearest Stryker subsidiary.
PROBLEM CAUSE ACTION
The face shield lens is
fogging. Not enough airflow is
circulating throughout
the helmet. Press the variable
control buttons to
increase the fan speed
if possible.
The power pack requires
replacement. Replace the power pack
with a fully charged
power pack.
The helmet is damaged. Replace the helmet.
The indicator lights fail
to flash and/or the fan
fails to turn on during
start up. The power pack requires
replacement. Replace the power pack
with a fully charged
power pack.
The power cord with
holster is damaged. Replace the power cord
with holster.
The helmet is damaged. Replace the helmet.
The helmet will not allow
airflow adjustment. The helmet is damaged. Replace the helmet.
The fan fails to provide
enough or any airflow. The fan speed is not
adjusted correctly. Press the variable
control buttons to
increase the fan speed.
The helmet is damaged. Replace the helmet.
The green microphone
indicator flashes rapidly
for several seconds.
The power pack may be
dislodged or the fan may
be experiencing physical
interference. Make sure the power
pack is secure in the
holster. Remove any fan
obstruction.
The red power loss
indicator light flashes on
and off. The steps within the To
Don a Surgical Helmet
section were performed
out of sequence.
See the To Don a
Surgical Helmet section
and perform the steps in
sequence.
The power pack requires
replacement. Replace the power pack
with a fully charged
power pack to prevent
the loss of air circulation
in the helmet.
Sporadic electrical
interference is
experienced. Electrical noise is
present. Turn off all the electrical
equipment not in use in
the room.
Relocate the electrical
equipment to maximize
the distance between
the equipment. Increase
spatial distance.
Plug equipment into
different outlets.
NOTE: If any component must be discarded, see the Disposal/Recycle section.