Still 6219, Original Instructions Manual

Page: 462 / 540

According to the standard
"DIN EN 1755:2015-02" they include:
●
checking the flame proof enclosure of the
truck control unit and the restricted breath-
ing housing for damage and integrity
●
compliance with the minimum intervals for
testing and inspection of the insulation re-
sistance
●
verification of a sufficient distance between
fixed and rotating parts
●
checking that the wheels, antistatic belts,
corona electrodes, drive belts are in good
condition and checking for any loss of con-
ductivity caused by contamination
●
verification of the potential equalisation and
the surface resistance of the seat and non-
metallic covers
●
verification of the proper function of security
monitoring systems and shut-down sys-
tems, including their sensors
●
regular replacement of safety-relevant parts
or wearing parts
●
verification of the correct rigidity of the
screw connections and the correct maxi-
mum gap at the closure line of pressure-
tight housings
●
verification of the lack of excessive wear
and axial play of brake linings and brakes,
in compliance with structural design safety
and of the correct positioning of the temper-
ature sensor and the brake lining wear sen-
sor after repair (depending on the series)
●
verification of the minimum thickness of
1 mm for the fork arm cladding
●
verification of the integrity of housings,
which provide a specific protection type
●
verification of the integrity of identification
plates and warning signs
Information for carrying out mainte-
nance
This section contains all the information re-
quired to determine when the truck requires
maintenance. Carry out maintenance work
within the time limits according to the hour me-
ter and using the maintenance check lists be-
low. This ensures that the truck remains ready
for operation and provides optimal perform-
ance and service life. It is also a precondition
for any warranty claims.
Maintenance
5
General maintenance information
446 56368011531 EN - 01/2021 - 05