Still 6219, Original Instructions Manual

Page: 185 / 540

Dynamic Load Control 1
WARNING
Risk of accident as a result of overloading!
Dynamic Load Control 1 is not a safety function and
does not release the driver from the duty to observe
the information specified in the load capacity dia-
gram!
WARNING
Risk of accident due to the slow response of the lift-
ing system!
If the lifting movements are configured to use low dy-
namics, the lifting system responds after a delay
when the operating device is released, even in an
emergency. The fork carriage does not stop immedi-
ately; instead, it takes approx. one second.
This behaviour may also occur when specific settings
are configured for the Dynamic Load Control 1.
–
Work with particular attention and care.
–
Observe the "Dynamics of the hydraulic move-
ments" section in the chapter entitled "Lifting".
Dynamic Load Control 1 improves the han-
dling of the load. This function protects the
truck and the load from abrupt movements.
Dynamic Load Control 1 regulates the lifting
and tilting dynamics and the driving dynamics
according to the following criteria:
●
Lift height
●
Load weight
Load movements which could lead to critical
conditions are slowed down if necessary.
Dynamic Load Control 1 intervenes in the fol-
lowing operating situations:
●
With a telescopic lift mast:
The fork carriage is at least 2.1 m off the
ground.
●
With a triple lift mast or NiHo lift mast:
The fork carriage is in the second lifting
stage
●
The load picked up exceeds 50% of the
nominal load
The driving speed is reduced to 5 km/h at a lift
height of 2.1 m and higher or in the second lift-
ing stage.
Operation
4
Load-dependant assistance systems
169 56368011531 EN - 01/2021 - 05