Still 6219, Original Instructions Manual

Page: 434 / 540

–
Adjust the stop (1) so that the battery will
later be centred on the change frame.
NOTE
To pick up batteries with large trays, fasten
the side stop in the outer bores, e.g. tray 366.
The battery must lie against the side stop (1)
and against the stops (3).
–
Re-tighten the screw joint (2).
–
Position the change frame properly on the
lift truck until the fork arm tips are touching
the feet (9).
When the change frame is on the lift truck, the
feet (5, 9) must be positioned close to the fork
arms on both sides.
NOTE
When using narrow pallet trucks with a dis-
tance of 400 mm between the outer edges of
the fork arms, the stop (8) must be removed.
When using pallet trucks with a distance of
≥ 525 mm between the outer edges of the fork
arms, the stop must be installed. The stop (8)
is connected to the battery change frame via
the screw joint (7).
Types of change frames
–
Observe the nameplate of the change
frame.
The following information is listed on the
nameplate:
1
The type of change frame
(observe the following table)
2 Maximum permissible load capacity
(see the nameplate on the battery)
3 The net weight of the change frame
The various battery change frames that are
available are designed for specific types of
battery.
Nameplate of the change frame

Operation
4
Replacing and transporting the battery
418 56368011531 EN - 01/2021 - 05