Still 6219, Original Instructions Manual

Page: 320 / 540

In the menu for the available hydraulic axles
for attachments, the designation
Hydraulic
axle
specifies the connection of the corre-
sponding auxiliary hydraulics. See also the
section entitled "Adjusting the hydraulic speed
for attachments" in this chapter.
Attachment example for an attachment for ad-
justment of the fork arms
1
Auxiliary hydraulics 1
2 Auxiliary hydraulics 2
3 Electrical connection for switch valve 1
(two switch valves are possible)
If an attachment is connected to the auxiliary
hydraulics 1 (1) and this attachment requires
another function, this is referred to as the
function of the auxiliary hydraulics 3.
There is an electrical connection (3) for the
switch valve that is required for this purpose.
The same applies to the auxiliary hydraulics 4,
which is fed from the auxiliary hydraulics 2 (2)
and is implemented by an additional connec-
tion for a switch valve that is not shown here.
NOTE
If one switch valve is used, the auxiliary hy-
draulic functions 1 & 3 and 2 & 4 that are sup-
plied by this switch valve cannot be operated
simultaneously. The switch valve supplies ei-
ther auxiliary hydraulics 1 & 3 or 2 & 4.
Adjusting the hydraulic speed for at-
tachments
If different attachments are mounted, the fleet
manager can adjust the hydraulic speed for at-
tachments and thus the flow rate of hydraulic
oil. Obtain the necessary values from the op-
erating instructions for the attachment. The
authorised service centre will help to make the
correct adjustments.
–
Observe the "Information on the auxiliary
hydraulics" in the "Technical data" chapter.
The "Information on the auxiliary hydraulics"
differs depending on the truck. Take this into
consideration when selecting the attachment.
1
3
2

Operation
4
Attachments
304 56368011531 EN - 01/2021 - 05