Stiga TITAN 740 D, Instructions For Use Manual

Page: 92 / 294

92
ENGLISH
EN
Original instructions for use
6.14 LUBRICATION
All lubrication points according to the table below
must be lubricated after every 50 operating hours
as well as after each clean.
Use a grease gun, filled with universal grease.
Pump until grease protrudes. The lubrication
points are shown in fig. 19-20.
Note the belts when lubricating. Belts
must not come into contact with oil or
grease.
6.15 VALVES
Valve adjustment and grinding should be carried
out by authorised workshops.
6.16 FUSES
The current strengths given in this sec-
tion are the maximum values of the fuse
that may be installed. If a higher cur-
rent fuse is installed there is a risk of
fire damage to the machine.
The machine has two fuse boxes.
Two fuse boxes (18:A and 18:B) are located in ac-
cordance with fig. 18. These contain the fuses ac-
cording to the table below. Depending on the
comfiguration of the machine some of the loca-
tions may be empty.
In the event of electrical faults, check and replace
blown fuses. If the fault persists, contact an author-
ised workshop.
GGP reserves the right to make alterations to the
product without prior notification
Object Lubrication nipples /
action
Fig.
Tension arm,
pump belt
1 lubrication nipple. 20:F
Lifting fork,
turning
1 lubrication nipple 20:A
Lifting fork, up-
down
2 lubrication nipples 20:B
Lifting cylinder 2 lubrication nipples 20:D
Control cylinder 2 lubrication nipples 20:E
Pivot point 3 lubrication nipples 20:C
Throttle cable Lubricate the cable ends
using an oil can at the
same time as activating
the respective control.
Preferably carried out by
two people.
19
Fault
Fuse
Location Rating
Dipped beam 18:A1 20 A
AC 18:A2 20 A
Main fuse, cabin 18:A3 30 A
Turn signal lamps 18:A4 10 A
Spare 18:A5
Parking lights, Horn,
Dipped beam relay
18:A6 10 A
Hazard 18:A7 10 A
AC 18:A8 10 A
Indicator lamps, buzzer,
hold valve transport posi-
tion
18:B1 10 A
Cutting height, sand
spreader, rear rake
18:B2 20 A
Cruise control, alternator 18:B3 10 A
Electric socket on panel 18:B4 10 A
Shut off pull 18:B5 30 A
PTO, warning lamp park-
ing, safety relay
18:B6 10 A
Spare 18:B7
Main fuse 18:B8 40 A