Stanley 73482, Instruction And Service Manual

Page: 19 / 248

SYMPTOM POSSIBLE CAUSE REMEDY PAGE REFERENCE
Placing tool does not
eject the collar from the
anvil
Pump Return Timer setting
incorrect – set too low
Adjust Return Timer to
recommended setting – refer to
pump instruction manual
Pump return pressure relief valve
set too low
Adjust return pressure relief valve
to correct setting – refer to pump
instruction manual
Low or erratic hydraulic pressure
supply
Refer to pump instruction manual
Worn or damaged hydraulic seals in
placing tool Inspect placing tool – replace worn
or damaged seals
13 - 16
Worn or damaged hydraulic sealing
surfaces in placing tool Inspect placing tool – replace worn
or damaged components
13 - 16
Pump internal/external oil leak Refer to pump instruction manual
Pull grooves on fastener
pintail stripped during
installation
Operator not pushing nose
completely onto fastener pintail
before operating tool
Instruct operator in correct
installation method
12 – 13
Incorrect fastener length / grip
length Worn or damaged jaw
segments Use correct fastener Check and
replace jaw set – refer to nose
equipment datasheet
12 – 13
Debris in jaw segments and/or
pintail grooves Clean jaw segments – refer to nose
equipment datasheet
Excessive sheet gap Close gap between sheets 12 – 13
Avdelok® or Avbolt® collar
not fully swaged
Improper tool operation 12 – 13
Worn Anvil bore
Check and replace Anvil – refer to
nose equipment datasheet
Pintail fails to release
from nose equipment Incorrect assembly of nose
equipment
Refer to nose equipment datasheet
Placing tool and
Hydraulic oil runs hot
Restriction in hydraulic line
Check hydraulic Quick Couplers
9 and 10 and replace if necessary
16
High ambient temperature
Hydraulic Quick Couplers
9 and 10 leak oil
Worn O-Ring in body of Quick
Coupler Male
9
Replace O-Ring and Back-up Ring in
Quick Coupler
9
16
19
O R I G I N A L I N S T R U C T I O N E N G L I S H