1-19
HDW-750/750CE V1
2.
Raise the white locking roller of the cassette compart-
ment assembly to set the cassette compartment
assembly to its up position.
3.
Slide the cam plate (A) of the right side of the cassette
compartment assembly in the direction of the arrow as
far as it can go.
Locking roller (WHT)
Cam plate (A)
4.
Hold the cassette compartment assembly at the position
shown in the illustration and insert the chassis so that
the two cassette guide pins enter into the round hole of
the stage.
At this moment, confirm that the white roller at the
other end of the joint arm that is adjusted of its position
at step 1, enters into the notch of the cam plate (A) on
the right side.
5.
Press the lid arm (L) of the cassette compartment
assembly and check to see that the stage can move up
and down smoothly. If the stage does not move up and
down smoothly, check above procedure starting from
step 1.
6.
Attach the cassette compartment assembly with three
screws.
n
Standard tightening torque :
10
x
10
_
2
N
.
m (1.0 kgf
.
cm)
Notch of
cam plate (A)
Precision screw
P1.4
x
3.5
Precision screw
P1.4
x
3.5
Lid arm (L)
Stage
Roller (WHT)
at the other end
Roller (WHT) of
step 1
Joint arm
Notch
Cassette
guide pin
Cassette guide pin
Round hole
of stage
Round hole
of stage
1-9. Removing and Reinstalling the Cassette Compartment
