6-3
HDW-750/750CE V1
4. Installing the CCD unit
(1) Clean the areas (the shaded portion
shown in illustration) that are contacting with
the front frame as shown in the illustration.
(2) Install the CCD unit to the front frame sub
assembly with the four stainless bolts (M3
x
8) and the four washers (SW3).
Standard tightening torque :
110
x
10
_
2
N
.
m (11 kgf
.
cm)
(3) Fix the heat pipe with the washer (SW2.6),
heat pipe retainer and the precision screw
(P2.6
x
5).
Cleaning
CCD unit
Mount cap
Installation
Removal
Mount lever
Set screw (B)
WP2
x
3
Set screw (B)
WP2
x
3
Set screw (A)
WP2
x
3
Set screw (A)
WP2
x
3
Filter (CC) knob
Filter (ND) knob
Inside panel assembly
Knob shaft (thin)
Knob shaft (thick)
1
Mark
B
5. Installing the filter knob
When a dual filter is incorporated :
(1) Rotate the knob shaft (thick) until the filter of
the thinnest color is visible from the front.
(2) Align the filter (CC) knob number “B” with
the mark on the inside panel assembly and
attach it with the use of the two set screws (A).
n
For the products having serial number of
70000 series and 80000 series, set the number
of the filter (CC) knob to the position “A” and
then install it.
(3) Rotate the knob shaft (thin) until the filter of
the thinnest color is visible from the front.
(4) Align the filter (ND) knob number “1” with
the mark on the inside panel assembly and
attach it with the use of the two set screws (B).
Standard tightening torque :
20 to 25
x
10
_
2
N
.
m (2 to 2.5 kgf
.
cm)
6-1. CCD Unit and Its Components Parts Replacement Procedure
1
Set screw
WP3
x
3
Filter knob
Inside panel assembly
Knob shaft
Mark
When a single filter is incorporated :
(5) Rotate the knob shaft until the filter of the
thinnest color is visible from the front.
(6) Align the filter knob number “1” with the
mark on the inside panel assembly and attach
it with the use of the two set screws.
Standard tightening torque :
53
x
10
_
2
N
.
m (5.3 kgf
.
cm)
