2-7
HDW-750/750CE V1
T plate assembly
Manual eject gear (A)
S plate assembly
S slider assembly
T slider assembly
Two front feet
Two front feet
Two rear feet
Two rear feet
Paper
Paper
Fig. 1
Fig. 2
Fig. 1
Fig. 2
Paper
Paper
2-1. Cleaning
2-1-6. Cleaning the S/T Plate Assemblies and S/T Slider Assemblies
n
The S1, S2 and T1, T2 tape guides are adjusted precisely. Be careful not to add any excessive force
during cleaning.
Tools
.
Cleaning cloth : 3-184-527-01
.
Cleaning fluid : 9-919-573-01
Procedure
1.
Clean the top surface (shaded portions in the illustration where slider passes over) of the S/T plate
assemblies using a cleaning cloth moistened with cleaning fluid.
2.
Rotate the manual eject gear (A) counter-clockwise until the S/T sliders come to the position as
shown in the illustration.
3.
Insert a piece of paper that is as thick as the paper of this manual between the front feet (2 locations)
of the S/T sliders and the rail. (Raising the slider slightly facilitates this work.) (Fig. 1)
4.
While pressing the S1 and T1 tape guides lightly on their top, remove a piece of paper that is inserted
in step 3. When a piece of paper is removed, stain and dirt adhere to the paper. Then insert a new
paper and remove it for cleaning. Repeat steps 3 and 4 until paper is no more stained. (Fig. 2)
5.
Insert a piece of paper between the rear feet (2 locations) of the S/T sliders and the rail.
6.
While pressing the S2 and T2 tape guides lightly on their top, remove a piece of paper. When a piece
of paper is removed, stain and dirt adhere to the paper. Then insert a new paper and remove it for
cleaning. Repeat steps 5 and 6 until paper is no more stained. (Fig. 2)
7.
Rotate the manual eject gear (A) clockwise to return to the unthreaded-end position.
