1-16
HDW-750/750CE V1
3.
When shaft of the board lever enters into the chassis,
slant the board lever and push down the board from its
top until it is firmly inserted to the board-to-board
connector of the MB-898 board.
4.
Reinstall it by reversing the steps of disassembling.
n
When routing the coaxial cable, route it through the
three hooks of the PC board holder (R), the projections
of the SDI shield plate and the clamp so that it does
not protrude out exceeding the board lever.
1-7. Removing and Reinstalling the Plug-in Boards
5.
Open the board lever in the direction of arrow A and
remove the board-to-board connector that is connected
to the MB-898 board.
6.
Raise the DVP board assembly in the direction of
arrow B by about 15 mm and align the projection of the
board holder (F) with the recess of the DVP-18 board.
7.
Slant the DVP board assembly to the front and remove it.
Reinstallation
1.
Raise the board lever to its upright position.
2.
Insert the DVP board assembly in a slant angle until the
projection of the PC board holder (F) meets the recess
of the DVP-18 board. At the above angle, raise the
DVP board assembly in the right angle and insert it.
DVP board
assembly
MB-898 board
Board lever
Board lever
A
A
B
Board-to-board
connector
Recess of
the DVP board
assembly
Projection
of the
board
holder (F)
DVP board
assembly
Coaxial cable
(WHT)
Coaxial cable
(WHT)
PC Board holder (R)
Projection of
the SDI shield plate
Projections of
the SDI shield plate
Hooks
Board lever
Board lever
Clamp
HDW-750 :
Serial No.10001 through 10119
Serial No.70001 through 70208
