Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
68(128)
Step-by-Step Instructions
2.
Remove the four screws indicated from the battery
cavity side of the base using a torque driver and a
Torx Plus size 5 bit.
3.
Slightly separate the loose end of the inner and outer
bases and remove the tab portion of the system
connector cover from its slot.
4.
Obtain a new system connector cover.
5.
Install the system connector cover by sliding its tab
portion into the slot adjacent to the system connector
and plugging the cover into the system connector.
6.
Press the two halves of the base back together and
install a 1.6 X 5mm screw into each of the four
screw locations shown using a torque screwdriver set
to 15 N·cm and a Torx Plus size 5 bit.
7.
Unplug and reinstall the system connector cover in
the system connector to verify the cover moves in
and out of place correctly.
•
Perform sections 2.2.3 - 2.2.4 the Base Reassembly procedure.