Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
36(128)
Step-by-Step Instructions
15.
Once both cables are connected, position the hinge
assembly in the inner flip cover’s hinge opening so
that the four screw holes in the hinge are aligned
with their corresponding screw holes in the display
carrier and the two alignment pegs extending from
the display carrier are within their corresponding
notches in the hinge assembly.
16.
Using a torque screwdriver set to 11 N·cm and a
JCIS No. 0 bit; install in the sequence shown,
a
new
flip hinge screw in each of the four screw locations
that hold the hinge assembly to the flip.
The sections of the Flip Reassembly following this section must be performed in sequential order
to reassemble the base portion of the phone.
