Working Instruction
,
Mechanical
3/00021-1/FEA 209 544/594 B
©
Sony Ericsson Mobile Communications AB
14(128)
Step-by-Step Instructions
5.
Orient the circuit board relative to the outer base
cover so that the camera is towards the inner surface
of the outer base cover and the end of the circuit
board with the system connector corresponds to the
outer base cover’s system connector opening.
6.
Rotate the circuit board so that it is at a 45 degree
angle to the outer base cover
7.
Insert the end of circuit board, in which the system
connector is attached, into the outer base cover so
that the system connector inserts into its opening in
the outer base cover.
8.
Hold the circuit board and the outer base cover in
this configuration using one hand and reconnect the
side speaker to the circuit board using the other
hand.
NOTE! When the side speaker’s board connector is
correctly connected, the wires coming off
of the side speaker’s connector extend
towards the center of the circuit board.
9.
Rotate the circuit board down into the outer base
cover.
