Sonnen sonnenBatterie 10, Installation Instructions Manual, Page: 50 / 100

7 | Installing the extension cabinet (optional)
50 / 100 Installation instructions sonnenBatterie 10
„
Note the size of the connector on the battery cable in terms of routing the cable (e.g.
when guiding it through the cable ducts).
7.1.2 Installing the mounting frame
„
Install the mounting frame on the wall as described in section Securing the mounting
frame [P. 24].
Sealing the openings [P. 26]:
„
Remove the four dummy plugs (diameter: 27.8 mm) for the extension cabinet from the
extension set.
Completing the mounting frame [P. 27]:
1.
3.
3.
2.
„
Install the battery shelves included in the extension set as shown in the figure.
„
Tighten the screws with a torque of 6 Nm .
7.1.3 Cable entry point
The specified degree of protection for the storage system and therefore touch
protection and protection against the ingress of water and foreign bodies is
only achieved when all openings on the storage system are sealed as described
in the product documentation.
„
Remove the reserve dummy plug (Ø 50) for the extension cabinet on the storage sys-
tem.
„
Use the cable entry points and grommets, if any, from the extension set to direct the
cables into the storage system and the extension cabinet.