Sonnen sonnenBatterie 10, Installation Instructions Manual, Page: 7 / 100

Safety | 2
KD-557 | 1000241 | EN | 02 7 / 100
2 Safety
2.1 Proper use
The sonnenBatterie 10 is a battery storage system which can be used to store electrical en-
ergy. Improper use poses a risk of death or injury to the user or third parties as well as dam-
age to the product and other items of value.
The following points must be observed at all times in order to ensure proper use :
• The transport and storage conditions must be observed.
• The storage system must only be used at a suitable installation location.
• The storage system must be fully installed in accordance with the installation instruc-
tions.
• The storage system must be installed by a licensed electrician. Country-specific regula-
tions concerning electrical installations must be observed at all times.
• The interfaces of the storage system must be connected in accordance with the
product documentation.
• Only use the storage system in its original state - without any unauthorised modifica-
tions - and when it is in proper working order.
• The storage system must not be installed in any kind of combination.
• An appropriate and readily accessible disconnect device shall be incorporated in the
fixed wiring.
• Repairs to the storage system must be carried out by an authorised service technician
only.
• The replacement of battery modules must be performed by authorised service techni-
cians only. When replacing batteries, replace with the same type and number of batter-
ies or battery modules.
Especially the following uses are not permissible:
• Operation in flammable environments or areas at risk of explosion.
• Operation in locations at risk of flooding.
• Outdoor operation.
• Operation of the battery modules outside of its storage system.
• Bypassing, blocking or tampering with protective devices.
Danger due to electrical voltage
5 min
The storage system contains live electrical parts, which poses a risk of electrical shock.
The storage system inverter also contains components with internal stored energy, which
carry voltage even after the storage system is switched off.
Therefore:
„
Disconnect the storage system from the power supply before any work on the system
is started (see Switching the storage system off to electrically isolate it [P. 83]).
Operating the storage system
• The storage system may only be operated as described in the product documentation.