![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-100/tigerswitch-100_management-manual_1300417269.webp)
VLAN C
OMMANDS
3-125
Related Commands
show vlan (3-131)
switchport mode
Use this command to configure the VLAN membership mode for a port.
Use the
no
form to restore the default.
Syntax
switchport mode
{
trunk
|
hybrid
}
no switchport mode
•
trunk
- Specifies a port as an end-point for a VLAN trunk. A trunk
is a direct link between two switches, so the port transmits tagged
frames that identify the source VLAN. However, note that frames
belonging to the port’s default VLAN (i.e., associated with the
PVID) are sent untagged.
•
hybrid
- Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following shows how to set the configuration mode to port 1, and
then set the switchport mode to hybrid:
Related Commands
switchport acceptable-frame-types
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
Summary of Contents for TigerSwitch 100
