![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-100/tigerswitch-100_management-manual_1300417027.webp)
S
YSTEM
D
EFAULTS
1-13
In the system flash memory, one file of each type must be set as the
start-up file. During a system boot, the diagnostic and operation code files
set as the start-up file are run, and then the start-up configuration file is
loaded.
System Defaults
The switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg.” To reset the switch defaults, this file
should be set as the startup configuration file. See “Saving or Restoring
Configuration Settings” on page 2-24.
The following table lists some of the basic system defaults.
Function
Parameter
Default
IP Settings
Management VLAN
1
DHCP
Enabled
BOOTP
Disabled
User Specified
Disabled
IP Address
0.0.0.0
Subnet Mask
255.0.0.0
Default Gateway
0.0.0.0
Web Management HTTP Server
Enabled
HTTP Port Number
80
SNMP
Community Strings
“public” (read only)
“private” (read/write)
Authentication Failure
Traps
Enabled
Link-up-Down Traps
Enabled
Summary of Contents for TigerSwitch 100
