SMC Networks TigerSwitch 100, Management Manual

Page: 71 / 334

A
DDRESS
T
ABLE
S
ETTINGS
2-41
CLI Configuration
Use the interface command to select the target port, then use the port
security action command to configure the port intrusion action (applies
to all ports). Use the port security command to enable security for the
port.
Address Table Settings
Switches store the addresses for all known devices. This information is
used to route traffic directly between the inbound and outbound ports. All
the addresses learned by monitoring traffic are stored in the dynamic
address table. You can also manually configure static addresses that are
bound to a specific port.
Setting Static Addresses
A static address can be assigned to a specific interface on this switch. Static
addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be
ignored and will not be written to the address table.
Console(config)#interface ethernet 1/5
Console(config-if)#port security action trap-and-shutdown
3-93
Console(config-if)#port security
Console(config-if)#