![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-100/tigerswitch-100_management-manual_1300417310.webp)
C
OMMAND
L
INE
I
NTERFACE
3-166
Port Trunking Commands
Ports can be statically grouped into an aggregate link to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can
use the Link Aggregation Control Protocol (LACP), also known as
802.1ad, to automatically negotiate a trunk link between this switch and
another network device. For static trunks, the switches have to be
compatible with the Cisco EtherChannel standard. For dynamic trunks,
the switches have to comply with LACP. This switch supports up to six
trunks. For example, a trunk consisting of two 1000 Mbps ports can
support an aggregate bandwidth of 4 Gbps when operating at full duplex.
Guidelines for Creating Trunks
• Finish configuring port trunks before you connect the corresponding
network cables between switches to avoid creating a loop.
• A trunk can contain up to four 10/100 Mbps ports or up to two 1000
Mbps ports.
• The ports at both ends of a connection must be configured as trunk
ports.
• All ports in a trunk must consist of the same media type (i.e.,
twisted-pair or fiber).
Command
Function
Mode Page
Manual Configuration Commands
interface port-channel Configures a trunk and enters interface
configuration mode for the trunk
GC
3-85
channel-group
Adds a port to a trunk
IC
3-167
Dynamic Configuration Command
lacp
Configures LACP for the current
interface
IC
3-168
Trunk Status Display Command
show interfaces status
port-channel
Shows trunk information
NE,
PE
3-95
Summary of Contents for TigerSwitch 100
