SMC Networks TigerSwitch 100, Management Manual

Page: 70 / 334

C
ONFIGURING THE
S
WITCH
2-40
Port Security Action
The switch allows you to set the security action to be taken when a port
intrusion is detected. This setting applies to all ports on the switch.
• Shutdown and Trap — Indicates the action to be taken when a port
security violation is detected:
- None : Indicates that no action should be taken. (This is the default.)
- Trap and Shutdown : Indicates that the port is to be disabled and an
SNMP trap message sent.
Web – Click Port, Port Security Action. Specify the security action for a
port intrusion, then click Apply.
Port Security Configuration
On the Port, Port Security Status page, you can enable/disable security for
any switch port. For each port number listed in the “Port” column, you
can configure the following parameter:
• Security Status — Enables or disables port security on the port.
(Default: disabled)
Note: If a port is disabled due to a security violation, it must be manually
re-enabled from the Port/Port Configuration page.
Web – Click Port, Port Security Status. Check the checkbox in the
“Security Status” column to enable security for a port, then click Apply.