![background image](http://html1.mh-extra.com/html/smc-networks/6726al2-fiche/6726al2-fiche_management-manual_1300177387.webp)
I
NTERFACE
C
OMMANDS
4-147
Example
The following example configures port 11 to use autonegotiation.
Related Commands
capabilities (4-147)
speed-duplex (4-145)
capabilities
This command advertises the port capabilities of a given interface during
autonegotiation. Use the
no
form with parameters to remove an advertised
capability, or the
no
form without parameters to restore the default values.
Syntax
[
no
]
capabilities
{
1000full
|
100full
|
100half
|
10full
|
10half
|
flowcontrol
|
symmetric
}
•
1000full
- Supports 1000 Mbps full-duplex operation
•
100full
- Supports 100 Mbps full-duplex operation
•
100half
- Supports 100 Mbps half-duplex operation
•
10full
- Supports 10 Mbps full-duplex operation
•
10half
- Supports 10 Mbps half-duplex operation
•
flowcontrol
-
Supports flow control
•
symmetric
(Gigabit only) - When specified, the port transmits and
receives pause frames; when not specified, the port will
auto-negotiate to determine the sender and receiver for asymmetric
pause frames. (
The current switch ASIC only supports symmetric pause
frames.
)
Default Setting
• 100BASE-TX: 10half, 10full, 100half, 100full
• 1000BASE-T: 10half, 10full, 100half, 100full, 1000full
• SFP: 1000full
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#
Summary of Contents for 6726AL2 FICHE
