![background image](http://html1.mh-extra.com/html/smc-networks/6726al2-fiche/6726al2-fiche_management-manual_1300177346.webp)
C
OMMAND
L
INE
I
NTERFACE
4-106
Command Usage
• If you enable port security, the switch stops learning new MAC
addresses on the specified port when it has reached a configured
maximum number. Only incoming traffic with source addresses
already stored in the dynamic or static address table will be accepted.
• First use the
port security max-mac-count
command to set the
number of addresses, and then use the port security command to
enable security on the port.
• Use the
no port security max-mac-count
command to disable port
security and reset the maximum number of addresses to the default.
• You can also manually add secure addresses with the
mac-address-table static
command.
• A secure port has the following restrictions:
• Cannot use port monitoring.
• Cannot be a multi-VLAN port.
• Cannot be connected to a network interconnection device.
• Cannot be a trunk port.
• If a port is disabled due to a security violation, it must be manually
re-enabled using the
no
shutdown
command.
Example
The following example enables port security for port 5, and sets the
response to a security violation to issue a trap message:
Related Commands
shutdown (4-149)
mac-address-table static (4-178)
show mac-address-table (4-179)
Console(config)#interface ethernet 1/5
Console(config-if)#port security action trap
Summary of Contents for 6726AL2 FICHE
