![background image](http://html1.mh-extra.com/html/smc-networks/6726al2-fiche/6726al2-fiche_management-manual_1300177044.webp)
I
NITIAL
C
ONFIGURATION
2-6
2. Type “configure” and press <Enter>.
3. Type “username guest password 0
password
,” for the Normal Exec
level, where
password
is your new password. Press <Enter>.
4. Type “username admin password 0
password
,” for the Privileged Exec
level, where
password
is your new password. Press <Enter>.
Note:
‘0’ specifies the password in plain text, ‘7’ specifies the
password in encrypted form.
Setting an IP Address
You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
Manual
— You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet as
the switch, you will also need to specify the default gateway router.
Dynamic
— The switch sends IP configuration requests to BOOTP or
DHCP address allocation servers on the network.
Username: admin
Password:
CLI session with the SMC6726AL2 is opened.
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#
Summary of Contents for 6726AL2 FICHE
